![]() ![]() First get an updated package list by entering the following command in to terminal if this has not been done today sudo apt update Once the dependencies were fixed, I ran the command "sudo dpkg -i octoscreen_2.7.4_b" again to install OctoScreen.To install Raspberry Pi OS software on a Raspberry Pi To fix this, I ran the command "sudo apt-get install -fix-broken" to resolve all the dependency problems. However, I encountered the same error you mentioned, which stated that "octoscreen" depends on "libgdk-pixbuf2.0-0" (version 2.25.2 or higher), but it was not installed. Then, I installed the necessary dependencies using the following command: "sudo apt-get install libgtk-3-0 xserver-xorg xinit x11-xserver-utils".Īfter that, I downloaded and installed OctoScreen using the following commands: Once the Raspberry Pi booted up, I ran the usual commands "sudo apt update" and "sudo apt upgrade" to update and upgrade the system.Īt this point, I set up my 3D printer in OctoPi because some recommend setting up the 3D printer before installing OctoScreen. (Raspberry Pi Imager sometimes gave me trouble.)Īfter flashing, I set the Wi-Fi settings using the "wpa_nf" file and added the "ssh" file to enable SSH. I used BalenaEtcher to flash the SD image to the SD card. I downloaded the SD image from the official OctoPi website. I reached out to someone on Fiverr - “wrasanga” and here’a what he did:
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |